Smartport Storm-Control Broadcast Level - Cisco 300 Series Cli Manual

Smartport Commands
78-21075-01 Command Line Interface Reference Guide
Syntax
smartport storm-control broadcast enable
Parameters
N/A
Default Configuration
N/A
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Example
switchxxxxxx(config)interface gi1
switchxxxxxx(config-if)#smartport storm-control broadcast enable

35.18 smartport storm-control broadcast level

Use the smartport storm-control broadcast level Interface Configuration (Ethernet,
port-channel) mode command to control the amount of Broadcast traffic allowed
on an interface.
Syntax
smartport storm-control broadcast level {
no smartport storm-control broadcast level
Parameters
•
level—Suppression level in percentage. Block the flooding of storm packets
when the value specified for level is reached. (Range 1 -100)
•
kbps—Maximum of kilobits per second of broadcast traffic on a port.
(Range 70–10000000)
Default Configuration
•
level—10%
•
kbps—10% of port speed in Kbps
level kbps
| kbps }
35
573