Cisco 300 Series Cli Manual page 431

Address Table Commands
78-21075-01 Command Line Interface Reference Guide
no port security mode
Parameters
•
max-addresses— Non secure mode with limited learning dynamic MAC
addresses. The static MAC addresses may be added on the port manually
by the bridge unicast unknown
•
lock— Secure mode without MAC learning. The static and secure MAC
addresses may be added on the port manually by the
unknown command.
•
secure permanent— Secure mode with limited learning permanent secure
MAC addresses with the permanent time-of-live. The static and secure
MAC addresses may be added on the port manually by the mac
address-table static command.
•
secure delete-on-reset— Secure mode with limited learning secure MAC
addresses with the delete-on-reset time-of-live. The static and secure MAC
addresses may be added on the port manually by the mac address-table
static command.
Default Configuration
The default port security mode is lock.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The default port mode is called regular. In this mode, the port allows unlimited
learning of dynamic addresses. The static MAC addresses may be added on the
port manually by the
The command may be used only when the interface in the regular (non-secure
with unlimited MAC learning) mode.
Use the port security mode command to change the default mode before the
security mode command.
Example
The following example sets the port security mode to Lock for gi7.
switchxxxxxx(config)interface gi7
command.
bridge unicast unknown
bridge unicast
command.
29
port
431