Wrr-Queue - Cisco 300 Series Cli Manual

Quality of Service (QoS) Commands
78-21075-01 Command Line Interface Reference Guide
Example - 3 This is an example of the output from the show qos interface policer
command.
switchxxxxxx# show qos interface policer
Ethernet gi1
Class map: A
Policer type: aggregate
Commited rate: 192000 bps
Commited burst: 9600 bytes
Exceed-action: policed-dscp-transmit
Class map: B
Policer type: single
Commited rate: 192000 bps
Commited burst: 9600 bytes
Exceed-action: drop
Class map: C
Policer type: none
Commited rate: N/A
Commited burst: N/A
Exceed-action: N/A
Example 4 - This is an example of the output from the show qos interface rate-limit
command.
switchxxxxxx# show qos interface rate-limit gi
Port rate-limit [kbps]
----- -----------------
gi1 1000

49.27 wrr-queue

Use the wrr-queue Global Configuration mode command to enable the tail-drop
mechanism on an egress queue. Use the no form of this command to disable the
tail-drop mechanism on an egress queue.
Syntax
tail-drop
wrr-queue
no wrr-queue
gi1
1
Burst [Bytes]
--------------
512K
49
823