Show Ip Arp Inspection Interfaces - Cisco Nexus 5500 Series Command Reference Manual

show ip arp inspection interfaces

show ip arp inspection interfaces
To display the trust state for the specified interface, use the show ip arp inspection interfaces
command.
Syntax Description ethernet
slot/[QSFP-module/]port
port-channel channel-number
Command Default None
Command Modes Any command mode
Command History Release
6.0(2)N1(2)
5.2(1)N1(1)
Examples This example shows how to display the trust state for a trusted interface:
switch# show ip arp inspection interfaces ethernet 2/1
Related Commands Command
ip arp inspection vlan
show ip arp inspection
show ip arp inspection vlan Displays DAI status for a specified list of VLANs.
show running-config dhcp
Cisco Nexus 5500 Series NX-OS Security Command Reference
284
show ip arp inspection interfaces {ethernet slot/[QSFP-module/]port | port-channel
channel-number}
Modification
Support for the QSFP+ GEM was added.
This command was introduced.
(Optional) Specifies the Ethernet interface and its slot number and port
number. The slot number is from 1 to 255. The QSFP-module number
is from 1 to 4. The port number is from 1 to 128.
The QSFP-module number applies only to the QSFP+
Note
Generic Expansion Module (GEM).
(Optional) Specifies that the output is for a port-channel interface.
Valid port-channel numbers are from 1 to 4096.
Description
Enables Dynamic ARP Inspection (DAI) for a specified list of VLANs.
Displays the DAI configuration status.
Displays DHCP snooping configuration, including the DAI
configuration.
Chapter Show Commands
OL-27883-02