Dell Z9500 Command Reference Manual page 1714

Defaults Not enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.4.1.0
7.6.1.0
7.5.1.0
Usage
The system supports up to 16 SNMP trap receivers.
Information
For the cam-utilization notification option, the system generates syslogs and
SNMP traps when the L3 host table or route table utilization goes above the
threshold.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
Related snmp-server community
Commands
snmp-server host
1714
•
temperature
For the snmp notification-type, enter one of the following
optional parameters:
•
authentication
•
coldstart
•
linkdown
•
linkup
Description
Introduced on the Z9500.
Added support for copy-config and ecmp traps.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP traps. Introduced on the S-
Series.
Introduced on the C-Series.
— enables SNMP and sets the community string.
— configures an SNMP trap receiver.
Simple Network Management Protocol (SNMP) and Syslog