AudioCodes Mediant 1000B User Manual page 521

User's Manual
appearance in the Allowed Audio Coders Group. For more information, see ''Prioritizing
Coder List in SDP Offer'' on page 497.
The following procedure describes how to configure Allowed Audio Coder Groups in the
Web interface. You can also configure Allowed Coder Groups using the table ini file
parameter, AllowedCodersGroup or CLI command, configure voip > sbc allowed-coders-
group group-0.

To configure an Allowed Audio Coders Group:
1. Open the Allowed Audio Coders Group page (Configuration tab > VoIP menu > SBC
> Allowed Audio Coders Group).
2. Configure an Allowed Audio Coders Group according to the parameters described in
the table below.
3. Click Submit, and then reset the device with a save ("burn") to flash memory.
Table 29-2: Allowed Audio Coders Group Table Parameter Descriptions
Parameter
Allowed Coders Group ID
[AllowedCodersGroupX]
Coder Name
CLI: name
[AllowedCodersGroupX_Name]
Version 6.8
Figure 29-4: Allowed Audio Coders Group Page
Defines an index number for the new table record.
Defines the audio coder. This can be a pre-defined coder or a
user-defined coder. The valid value for user-defined coders is a
string of up to 25 characters (case-insensitive). For example,
"HD.123" (without quotes).
Note: Each coder type (e.g., G.729) can be configured only once
per Allowed Coders Group.
Description
521 Mediant 1000B Gateway & SBC
29. SBC Configuration