AudioCodes Mediant 1000B User Manual page 924

Parameter
CLI: snd-isdn-ser-aftr-restart
[SendISDNServiceAfterResta
rt]
EMS: Support Redirect
InFacility
[SupportRedirectInFacility]
CLI: call-re-rte-mode
[CallReroutingMode]
EMS: Enable CIC
[EnableCIC]
Web/EMS: AoC Support
[EnableAOC]
User's Manual

The option Any is only applicable if TerminationSide is set to 0
(i.e., User side).

The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Enables the device to send an ISDN SERVice message per trunk
upon device reset. The messsage (transmitted on the trunk's D-
channel) indicates the availability of the trunk's B-channels (i.e.,
trunk in service).

[0] = Disable (default)

[0] = Enable
Determines whether the Redirect Number is retrieved from the
Facility IE.

[0] = (Default) Not supported.

[1] = Supports partial retrieval of Redirect Number (number only)
from the Facility IE in ISDN Setup messages. This is applicable
to Redirect Number according to ECMA-173 Call Diversion
Supplementary Services.
Note: To enable this feature, the parameter
ISDNDuplicateQ931BuffMode must be set to 1.
Determines whether ISDN call rerouting (call forward) is performed
by the PSTN instead of by the SIP side. This call forwarding is
based on Call Deflection for Euro ISDN (ETS-300-207-1) and QSIG
(ETSI TS 102 393).

[0] Disable (default).

[1] Enable = Enables ISDN call rerouting. When the device
sends the INVITE message to the remote SIP entity and
receives a SIP 302 response with a Contact header containing a
URI host name that is the same as the device's IP address, the
device sends a Facility message with a Call Rerouting invoke
method to the ISDN and waits for the PSTN side to disconnect
the call.
Note: When this parameter is enabled, ensure that you configure in
the Inbound IP Routing table (PSTNPrefix ini file parameter) a rule
to route the redirected call (using the user part from the 302 Contact
header) to the same Trunk Group from where the incoming Tel-to-
IP call was received.
Determines whether the Carrier Identification Code (CIC) is relayed
to ISDN.

[0] = (Default) Do not relay the Carrier Identification Code (CIC)
to ISDN.

[1] = CIC is relayed to the ISDN in Transit Network Selection
(TNS) IE.
If enabled, the CIC code (received in an INVITE Request-URI) is
included in a TNS IE in the ISDN Setup message.
For example: INVITE sip:555666;cic=2345@100.2.3.4 sip/2.0.
Notes:

This feature is supported only for SIP-to-ISDN calls.

The parameter AddCicAsPrefix can be used to add the CIC as a
prefix to the destination phone number for routing IP-to-Tel calls.
Enables the interworking of ISDN Advice of Charge (AOC)
messages to SIP.
924
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034