AudioCodes Mediant 1000B User Manual page 546

Note: SIP URI host name (source and destination) manipulations can also be
configured in the IP Group table. These manipulations are simply host name
substitutions with the names configured for the source and destination IP Groups,
respectively.
The following procedure describes how to configure IP-to-IP Outbound Manipulation rules
in the Web interface. You can also configure these rules using the table ini file parameter,
IPOutboundManipulation or CLI command, configure voip > sbc manipulations ip-
outbound-manipulation.

To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click Add; the following dialog box appears:
Figure 29-13: IP to IP Outbound Manipulation Page
3. Configure an IP-to-IP outbound manipulation rule according to the parameters
described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 29-9: IP to IP Outbound Manipulation Table Parameter Description
Parameter
Index
[IPOutboundManipulation_Index]
Manipulation Name
CLI: manipulation-name
[IPOutboundManipulation_Manipu
lationName]
User's Manual
Defines an index number for the new table record.
Defines an arbitrary name to easily identify the manipulation
name.
The valid value is a string of up to 20 characters. By default,
no value is defined.
546
Mediant 1000B Gateway & SBC
- Add Dialog Box
Description
Document #: LTRT-27034