AudioCodes Mediant 1000B User Manual page 543

User's Manual

To configure an IP-to-IP Inbound Manipulation rule:
1. Open the IP to IP Inbound Manipulation page (Configuration tab > VoIP menu > SBC
> Manipulations SBC > IP to IP Inbound).
2. Click Add; the following dialog box appears:
Figure 29-12: IP to IP Inbound Manipulation Page
3. Configure the IP-to-IP inbound manipulation rule according to the parameters
described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 29-8: IP to IP Inbound Manipulation Parameter Descriptions
Parameter
Index
[IPInboundManipulation_Index]
Manipulation Name
CLI: manipulation-name
[IPInboundManipulation_Manipulati
onName]
Matching Characteristics - Rule
Additional Manipulation
CLI: is-additional-manipulation
[IPInboundManipulation_IsAddition
alManipulation]
Version 6.8
Defines an index number for the new table record.
Defines an arbitrary name to easily identify the manipulation
rule.
The valid value is a string of up to 20 characters. By default,
no value is defined.
Determines whether additional SIP URI user part
manipulation is done for the table entry rule listed directly
above it.

[0] No = (Default) Regular manipulation rule (not done in
addition to the rule above it).

[1] Yes = If the above row entry rule matched the call,
consider this row entry as a match as well and perform
the manipulation specified by this rule.
Note: Additional manipulation can only be done on a
different SIP URI, source or destination, to the rule
configured in the row above as configured by the
'Manipulated URI' parameter (see below).
543
29. SBC Configuration
- Add Dialog Box
Description
Mediant 1000B Gateway & SBC