Number Manipulation Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
51.10.15

Number Manipulation Parameters

The number manipulation parameters are described in the table below.
Parameter
[ManipulateIP2PSTNReferTo]
Web: Use EndPoint Number
As Calling Number Tel2IP
EMS: Use EP Number As
Calling Number Tel to IP
CLI: epn-as-cpn-tel2ip
[UseEPNumAsCallingNumTel
2IP]
Web: Use EndPoint Number
As Calling Number IP2Tel
EMS: Use EP Number As
Calling Number IP to Tel
CLI: epn-as-cpn-ip2tel
[UseEPNumAsCallingNumIP2
Tel]
Version 6.8
Table 51-69: Number Manipulation Parameters
Enables the manipulation of the called party (destination) number
according to the SIP Refer-To header received by the device for
TDM (PSTN) blind transfer. The number in the SIP Refer-To header
is manipulated for all types of blind transfers to the PSTN (TBCT,
ECT, RLT, QSIG, FXO, and CAS).

[0] Disable (default)

[1] Enable
During the blind transfer, the device initiates a new call to the PSTN
and the destination number of this call can be manipulated if this
parameter is enabled. When enabled, the manipulation is done as
follows:
If you configure a value for the xferPrefix parameter, then this
1
value (string) is added as a prefix to the number in the Refer-To
header.
This called party number is then manipulated using the IP-to-Tel
2
Destination Phone Number Manipulation table. The source
number of the transferred call is taken from the original call,
according to its initial direction:

Source number of the original call if it is a Tel-to-IP call

Destination number of the original call if it is an IP-to-Tel call
This source number can also be used as the value for the 'Source
Prefix' field in the IP-to-Tel Destination Phone Number
Manipulation table. The local IP address is used as the value for
the 'Source IP Address' field.
Note: This manipulation does not affect IP-to-Trunk Group routing
rules.
Enables the use of the B-channel number as the calling number
(sent in the From field of the INVITE) instead of the number received
in the Q.931 Setup message, for Tel-to-IP calls.

[0] Disable (default)

[1] Enable
For example, if the incoming calling party number in the Q.931 Setup
message is "12345" and the B-channel number is 17, then the
outgoing INVITE From header is set to "17" instead of "12345".
Note: When enabled, this feature is applied before routing and
manipulation on the source number.
Enables the use of the B-channel number as the calling party
number (sent in the Q.931 Setup message) instead of the number
received in the From header of the INVITE, for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
For example, if the incoming INVITE From header contains "12345"
and the destined B-channel number is 17, then the outgoing calling
party number in the Q.931 Setup message is set to "17" instead of
"12345".
51. Configuration Parameters Reference
Description
965 Mediant 1000B Gateway & SBC