AudioCodes Mediant 1000B User Manual page 828

Parameter
Web: MWI Off Digit Pattern
EMS: MWI Off Code
CLI: mwi-off-dig-ptrn
[MWIOffCode]
Web: MWI On Digit Pattern
EMS: MWI On Code
CLI: mwi-on-dig-ptrn
[MWIOnCode]
Web: MWI Suffix Pattern
EMS: MWI Suffix Code
CLI: mwi-suffix-pattern
[MWISuffixCode]
Web: MWI Source Number
EMS: MWI Source Name
CLI: mwi-source-number
[MWISourceNumber]
CLI: mwi-subs-ipgrpid
[MWISubscribeIPGroupID]
[NotificationIPGroupID]
[MWIQsigMsgCentreldIDPartyNum
ber]
Digit Patterns The following digit pattern parameters apply only to voice mail applications that use
the DTMF communication method. For the available pattern syntaxes, refer to the CPE Configuration
Guide for Voice Mail.
User's Manual
Defines the digit code used by the device to notify the PBX that
there are no messages waiting for a specific extension. This
code is added as prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device to notify the PBX of
messages waiting for a specific extension. This code is added
as prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device as a suffix for 'MWI
On Digit Pattern' and 'MWI Off Digit Pattern'. This suffix is
added to the generated DTMF string after the extension
number.
The valid range is a 25-character string.
Defines the calling party's phone number used in the Q.931
MWI Setup message to PSTN. If not configured, the channel's
phone number is used as the calling number.
Defines the IP Group ID used when subscribing to an MWI
server. The 'The SIP Group Name' field value of the IP Group
table is used as the Request-URI host name in the outgoing
MWI SIP SUBSCRIBE message. The request is sent to the IP
address defined for the Proxy Set that is associated with the IP
Group. The Proxy Set's capabilities such as proxy redundancy
and load balancing are also applied to the message.
For example, if the 'SIP Group Name' field of the IP Group is set
to "company.com", the device sends the following SUBSCRIBE
message:
SUBSCRIBE sip:company.com...
Instead of:
SUBSCRIBE sip:10.33.10.10...
Note: If this parameter is not configured, the MWI SUBSCRIBE
message is sent to the MWI server as defined by the
MWIServerIP parameter.
Defines the IP Group ID to which the device sends SIP NOTIFY
MWI messages.
Notes:

This is used for MWI Interrogation. For more information on
the interworking of QSIG MWI to IP, see Message Waiting
Indication on page 422.

To determine the handling method of MWI Interrogation
messages, use the
TrunkGroupSettings_MWIInterrogationType, parameter (in
the Trunk Group Settings table).
Defines the Message Centred ID party number used for QSIG
MWI messages. If not configured (default), the parameter is not
included in MWI (activate and deactivate) QSIG messages.
The valid value is a string.
828
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034