Ip Destinations Connectivity Feature - AudioCodes Mediant 1000B User Manual

Parameter
Call Setup Rules Set ID
CLI: call-setup-rules-set-id
[PstnPrefix_CallSetupRulesSetId]
Operation (Destination)
Web: Trunk Group ID
CLI: trunk-group-id
[PstnPrefix_TrunkGroupId]
Web: Trunk ID
CLI: trunk-id
[PstnPrefix_TrunkId]
Web: IP Profile ID
CLI: ip-profile-id
[PstnPrefix_ProfileId]
Web: Source IP Group ID
CLI: src-ip-group-id
[PstnPrefix_SrcIPGroupID]
24.4

IP Destinations Connectivity Feature

The device can be configured to check the integrity of the connectivity to IP destinations of
Tel-to-IP routing rules in the Outbound IP Routing table. The IP Connectivity feature can be
used for the Alternative Routing feature, whereby the device attempts to re-route calls from
unavailable Tel-to-IP routing destinations to available ones (see ''Alternative Routing Based
on IP Connectivity'' on page 398).
The device supports the following methods for checking the connectivity of IP destinations:
User's Manual
is defined and it is associated with a different SRD, the
incoming SIP call is rejected. If the 'Source IP Group ID'
parameter is not defined, the SRD's default IP Group is used. If
there is no valid source IP Group, the call is rejected.
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device
routes the call to the destination according to the routing rule's
configured action, only after it has performed the Call Setup
rules.
For configuring Call Setup rules, see ''Configuring Call Setup
Rules'' on page 233.
For IP-to-Tel calls: Defines the Trunk Group to where the
incoming SIP call is sent.
For IP-to-IP calls: Identifies the call as an IP-to-IP call if this
parameter is set to -1.
Defines the Trunk to where the incoming SIP call is sent.
Notes:

If both 'Trunk Group ID' and 'Trunk ID' parameters are
configured in the table, the routing is done according to the
'Trunk Group ID' parameter.

The method for selecting the trunk's channel to which the IP
call is sent is configured by the global parameter,
ChannelSelectMode.

Currently, this field can only be configured using the ini file.
Assigns an IP Profile (configured in ''Configuring IP Profiles'' on
page 302) to the call.
For IP-to-Tel calls: Defines the IP Group associated with the
incoming IP call. This is the IP Group that sent the INVITE
message. This IP Group can later be used as the 'Serving IP
Group' in the Account table for obtaining authentication user
name/password for this call.
For IP-to-IP calls: Assigns the IP Group to the incoming IP call.
This IP Group can later be used for outbound IP routing and as
the 'Serving IP Group' in the Account table for obtaining
authentication user name/password for this call.
For configuring registration accounts in the Account table, see
''Configuring Account Table'' on page 279.
396
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034