Test Call Configuration Examples - AudioCodes Mediant 1000B User Manual

Analog & digital voip media gateway enterprise session border controller gateway & e-sbc
Hide thumbs Also See for Mediant 1000B:
Table of Contents

Advertisement

To configure SBC call testing:
1.
Configure the test call parameters (for a full description, see ''SIP Test Call
Parameters'' on page 740):
a.
Open the Test Call Settings page (Configuration tab > System menu > Test
Call > Test Call Settings).
b.
In the 'Test Call ID' field, enter a prefix number for the simulated test endpoint on
the device.
c.
In the 'SBC Test ID' field, enter a called prefix number for identifying the call as
an SBC test call.
d.
Click Submit.
2.
Configure regular SBC call processing rules for called number prefix "101", such as
classification and IP-to-IP routing through a proxy server.
49.7

Test Call Configuration Examples

Below are a few examples of test call configurations.
Single Test Call Scenario: This example describes the configuration of a simple test
call scenario that includes a single test call between a simulated test endpoint on the
device and a remote endpoint.
Test Call table configuration:
Alternatively, if you want to route the test call using the Outbound IP Routing table for
the Gateway / IP-to-IP application, configure the following:
Test Call table configuration:
User's Manual
Figure 49-7: Test Call Settings Page
Figure 49-8: Single Test Call Example
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.30.40.01"
Call Party: Caller
Test Mode: Once
Endpoint URI: 101@10.0.0.1
Route By: GW Tel2IP
Called URI: 201@10.30.40.1
Call Party: Caller
Mediant 1000B Gateway & SBC
708
Document #: LTRT-27034

Advertisement

Table of Contents
loading

Table of Contents