Multiple Voip Network Interfaces And Vlan Parameters; Routing Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
Settings
CLI: configure voip/ether-
group
[EtherGroupTable]

51.2.2 Multiple VoIP Network Interfaces and VLAN Parameters

The IP network interfaces and VLAN parameters are described in the table below.
Table 51-10: IP Network Interfaces and VLAN Parameters
Parameter
Interface Table
Web: Interface Table
EMS: IP Interface Settings
CLI: configure voip >
interface network-if display
[InterfaceTable]
[EnableNTPasOAM]

51.2.3 Routing Parameters

The IP network routing parameters are described in the table below.
Parameter
Web: Send ICMP
Unreachable Messages
[DisableICMPUnreachable]
Version 6.8
groups. The format of this parameter is as follows:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For a description of this parameter, see Configuring Ethernet Port
Groups on page 111.
Note: For this parameter to take effect, a device reset is required.
This table parameter configures the Interface table.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of this table, see ''Configuring IP Network
Interfaces'' on page 116.
Note: For this parameter to take effect, a device reset is required.
Defines the application type for Network Time Protocol (NTP) services.

[1] = OAMP (default)

[0] = Control
Note: For this parameter to take effect, a device reset is required.
Table 51-11: IP Network Routing Parameters
Enables sending of ICMP Unreachable messages.

[0] Enable = (Default) Device sends these messages.

[1] Disable = Device does not send these messages.
729
51. Configuration Parameters Reference
Description
Description
Description
Mediant 1000B Gateway & SBC