48.2
FXS Line Testing
The device can test the telephone lines connected to its FXS ports, using the SNMP
acAnalogFxsLineTestTable table. These tests provide various line measurements. In
addition to these tests, a keep-alive test is also done every 100 msec on each of the
analog ports to detect communication problems with the analog equipment and
overheating of the FXS ports.
Hardware revision number
Temperature (above or below limit, only if a thermometer is installed)
Hook state
Coefficients checksum
Message waiting indication status
Ring state
Reversal polarity state
Note:
Use the Analog Line testing mechanism only for monitoring and never when
there are calls in progress.
User's Manual
Mediant 1000B Gateway & SBC
698
Document #: LTRT-27034