AudioCodes Mediant 1000B User Manual page 117

User's Manual

Underlying Ethernet Device: Layer-2 bridging device and assigned a VLAN ID. As the
Ethernet Device is associated with an Ethernet Port Group, this is useful for setting
trusted and un-trusted networks on different physical Ethernet ports. Multiple entries in
the Interface table may be associated with the same Ethernet Device, providing multi-
homing IP configuration (i.e., multiple IP addresses on the same interface/VLAN).
Complementing the Interface table is the Static Route table, which lets you configure static
routing rules for non-local hosts/subnets. For more information, see ''Configuring Static IP
Routing'' on page 123.
Notes:
•
Before configuring IP interfaces, it is recommended that you read the IP interface
configuration guidelines in ''Interface Table Configuration Guidelines'' on page
119.
•
The IPv6 feature is available only if the device is installed with a Software License
Key that includes this feature. For installing a Software License Key, see Software
License Key on page 599.
The following procedure describes how to configure the IP network interfaces in the Web
interface. You can also configure IP network interfaces using the table ini file parameter,
InterfaceTable or CLI command, configure voip/interface network-if.

To configure IP network interfaces:
1. Open the Interface Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).
2. Click Add; a dialog box appears.
3. Configure the IP network interface according to the parameters described in the table
below.
4. Click Submit.
To view configured network interfaces that are currently active, click the IP Interface
Status Table
642.
Version 6.8
button. For more information, see ''Viewing Active IP Interfaces'' on page
117
12. Network
Mediant 1000B Gateway & SBC