AudioCodes Mediant 1000B User Manual page 743

User's Manual
Parameter
Web: Media CDR Report
Level
[MediaCDRReportLevel]
Web/EMS: Debug Level
CLI: configure
system/logging/debug-level
[GwDebugLevel]
Web: Syslog Optimization
CLI: configure
system/logging/syslog-
optimization
[SyslogOptimization]
CLI: mx-syslog-lgth
[MaxBundleSyslogLength]
Web: Syslog CPU Protection
CLI: configure
system/logging/syslog-cpu-
protection
Version 6.8
parameter EnableSyslog is set to 1).
Enables media-related CDRs of SBC calls to be sent to a Syslog
server and determines the call stage at which they are sent.

[0] None = (Default) No media-related CDR is sent.

[1] End Media = Sends a CDR only at the end of the call.

[2] Start & End Media = Sends a CDR once the media starts. In
some calls it may only be after the call is established, but in other
calls the media may start at ringback tone. A CDR is also sent
upon termination (end) of the media in the call.

[3] Update & End Media = Sends a CDR when an update occurs
in the media of the call. For example, a call starts and a ringback
tone occurs, a re-INVITE is sent for a fax call and as a result, a
CDR with the MediaReportType field set to "Update" is sent, as
the media was changed from voice to T.38. A CDR is also sent
upon termination (end) of the media in the call.

[4] Start & End & Update Media = Sends a CDR at the start of the
media, upon an update in the media (if occurs), and at the end of
the media.
Note: To enable CDR generation as well as enable signaling-related
CDRs, use the CDRReportLevel parameter.
Enables Syslog debug reporting and logging level.

[0] No Debug = (Default) Debug is disabled.

[1] Basic = Sends debug logs of incoming and outgoing SIP
messages.

[5] Detailed = Sends debug logs of incoming and outgoing SIP
message as well as many other logged processes.
Note: When debug reporting is enabled, in order to view Syslog
messages with Wireshark, you need to install AudioCodes Wireshark
plug-in (acsyslog.dll). Once the plug-in is installed, the Syslog
messages are decoded as "AC SYSLOG" and are displayed using
the 'acsyslog' filter instead of the regular 'syslog' filter.
Enables the device to accumulate and bundle multiple debug
messages into a single UDP packet and then send it to a Syslog
server. The benefit of this feature is that it reduces the number of
UDP Syslog packets, thereby improving (optimizing) CPU utilization.

[0] Disable

[1] Enable (default)
Note: The size of the bundled message is configured by the
MaxBundleSyslogLength parameter.
Defines the maximum size (in bytes) threshold of logged Syslog
messages bundled into a single UDP packet, after which they are
sent to a Syslog server.
The valid value range is 0 to 1220 (where 0 indicates that no
bundling occurs). The default is 1220.
Note: This parameter is applicable only if the GWDebugLevel
parameter is enabled.
Enables the protection of the device's CPU resources during debug
reporting, ensuring voice traffic is unaffected. If CPU resources drop
(i.e., high CPU usage) to a critical level (threshold), the device
automatically lowers the debug level to free up CPU resources that
743
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC