Configuring Snmp Trusted Managers; Configuring Snmp V3 Users - AudioCodes Mediant 1000B User Manual

8.3

Configuring SNMP Trusted Managers

The SNMP Trusted Managers table lets you configure up to five SNMP Trusted Managers
based on IP addresses. By default, the SNMP agent accepts SNMP Get and Set requests
from any IP address as long as the correct community string is used in the request.
Security can be enhanced by using Trusted Managers, which is an IP address from which
the SNMP agent accepts and processes SNMP requests.
The following procedure describes how to configure SNMP trusted managers in the Web
interface. You
SNMPTrustedMgr_x or CLI command, configure system > snmp > trusted-managers.

To configure SNMP Trusted Managers:
1. Open the SNMP Trusted Managers page (Configuration tab > System menu >
Management > SNMP > SNMP Trusted Managers).
2. Select the check box corresponding to the SNMP Trusted Manager that you want to
enable and for whom you want to define an IP address.
3. Define an IP address in dotted-decimal notation.
4. Click Submit, and then save ("burn") your settings to flash memory.
8.4

Configuring SNMP V3 Users

The SNMP v3 Users table lets you configure up to 10 SNMP v3 users for authentication
and privacy.
The following procedure describes how to configure SNMP v3 users in the Web interface.
You can also configure this using the table ini file parameter, SNMPUsers or CLI
command, configure system > snmp v3-users.
User's Manual
can also configure
Figure 8-2: SNMP Trusted Managers
80
Mediant 1000B Gateway & SBC
this using the table
Document #: LTRT-27034
ini file parameter,