AudioCodes Mediant 1000B User Manual page 110

The following procedure describes how to configure the Ethernet ports in the Web
interface. You can also configure these ports using the table ini file parameter,
PhysicalPortsTable or CLI command, configure voip/physical-port.

To configure the physical Ethernet ports:
1. Open the Physical Ports Settings page (Configuration tab > VoIP menu > Network >
Physical Ports Table).
2. Select a port that you want to configure by clicking its table row, and then click Edit;
the following dialog box appears:
Figure 12-2: Physical Ports Settings Page - Edit Record
3. Configure the port according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 4: Physical Port Settings Parameter Descriptions
Parameter
Port
CLI: port
[PhysicalPortsTable_Port]
Mode
CLI: mode
[PhysicalPortsTable_Mode]
Native Vlan
CLI: native-vlan
[PhysicalPortsTable_NativeVlan]
Speed & Duplex
CLI: speed-duplex
[PhysicalPortsTable_SpeedDuplex]
User's Manual
Description
(Read-only) Displays the port number.
(Read-only) Displays the mode of the port:

[0] Disable

[1] Enable (default)
Defines the Native VLAN or PVID of the port. Incoming
packets without a VLAN ID are tagged with this VLAN. For
outgoing packets, if the VLAN ID as defined in the
Interface table is the same as the Native VLAN ID, the
device sends the packet without a VLAN; otherwise, the
VLAN ID as defined in the Interface table takes
precedence.
The valid value range is 1 to 4096. The default is 1.
Defines the speed and duplex mode of the port.

[0] 10BaseT Half Duplex

[1] 10BaseT Full Duplex

[2] 100BaseT Half Duplex

[3] 100BaseT Full Duplex

[4] Auto Negotiation (default)

[6] 1000BaseT Half Duplex

[7] 1000BaseT Full Duplex
110
Mediant 1000B Gateway & SBC
Document #: LTRT-27034