AudioCodes Mediant 1000B User Manual page 54

The table below describes the areas of the Home page.
Item #
1 Displays the highest severity of an active alarm raised (if any) by the device:

Green: No alarms

Red: Critical alarm

Orange: Major alarm

Yellow: Minor alarm
To view active alarms, click the Alarms area to open the Active Alarms page (see
Viewing Active Alarms on page 631).
2 Module slot number.
3 Module type (e.g., FXS, FXO, and DIGITAL)
4 Module status icon:

(green): Module has been inserted or is correctly configured

(gray): Module was removed and "Reserved" is displayed

(red): Module failure and "Failure" is displayed
5 Port (trunk or channel) status icon.
Icon
(grey)
(green)
(yellow)
(red)
(blue)
(light orange)
(dark orange)
If you click a port, a shortcut menu appears with commands allowing you to do the
following:

Reset channel (Analog ports only): Resets the analog port (see Resetting an
Analog Channel on page 573)
User's Manual
Table 6-7: Home Page Description
Description
Trunk Description
(Digital Module)
Disable: Trunk not configured (not
in use)
Active - OK: Trunk synchronized
RAI Alarm: Remote Alarm Indication
(RAI), also known as the Yellow
Alarm
LOS / LOF Alarm: Loss due to LOS
(Loss of Signal) or LOF (Loss of
Frame)
AIS Alarm: Alarm Indication Signal
(AIS), also known as the Blue Alarm
D-Channel Alarm: D-channel alarm
NFAS Alarm
54
Mediant 1000B Gateway & SBC
Channel Description
(Analog Module)
Idle: Channel is currently on-
hook
Call Connected: Active RTP
stream
-
Not Connected: No analog
line is connected to this port
or port out of service due to
Serial Peripheral Interface
(SPI) failure (applicable only
to FXO interfaces)
Handset Offhook: Channel is
off-hook, but there is no
active RTP session
-
-
Document #: LTRT-27034