AudioCodes Mediant 1000B User Manual page 1004

Parameter
Web: Accounting Server
IP Address
CLI: accounting-server-ip
[RADIUSAccServerIP]
Web: Accounting Port
CLI: accounting-port
[RADIUSAccPort]
Web/EMS: RADIUS
Accounting Type
CLI: radius-accounting
[RADIUSAccountingTyp
e]
Web: AAA Indications
EMS: Indications
CLI: aaa-indications
[AAAIndications]
General RADIUS Parameters
Web: Use RADIUS for
Web/Telnet Login
EMS: Web Use Radius
Login
CLI: enable-mgmt-login
[WebRADIUSLogin]
Web: RADIUS
Authentication Server IP
Address
EMS: RADIUS Auth
Server IP
CLI: auth-server-ip
[RADIUSAuthServerIP]
Web: RADIUS
Authentication Server Port
EMS: RADIUS Auth
Server Port
CLI: auth-server-port
[RADIUSAuthPort]
Web: RADIUS Shared
Secret
User's Manual
Defines the IP address of the RADIUS accounting server.
Defines the port of the RADIUS accounting server.
The default is 1646.
Determines when the RADIUS accounting messages are sent to the
RADIUS accounting server.

[0] At Call Release = (Default) Sent at call release only.

[1] At Connect & Release = Sent at call connect and release.

[2] At Setup & Release = Sent at call setup and release.
Determines the Authentication, Authorization and Accounting (AAA)
indications.

[0] None = (Default) No indications.

[3] Accounting Only = Only accounting indications are used.
Enables RADIUS queries for Web and Telnet login authentication.
When enabled, logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device communicates
with a user-defined RADIUS server and verifies the given username
and password against a remote database, in a secure manner.

[0] Disable (default)

[1] Enable
Notes:

For RADIUS login authentication to function, you also need to set
the following parameters:

EnableRADIUS = 1 (Enable)

WebAuthMode = 0 (Basic Mode)

RADIUS authentication requires HTTP basic authentication, where
the username and password are transmitted in clear text over the
network. Therefore, it's recommended to set the HTTPSOnly
parameter to 1 to force the use of HTTPS, since the transport is
encrypted.
Defines the IP address of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
Defines the port of the RADIUS authentication server.
Note: For this parameter to take effect, a device reset is required.
Defines the 'secret' used to authenticate the device to the RADIUS
server. This should be a cryptically strong password.
1004
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034