AudioCodes Mediant 1000B User Manual page 534

Parameter
Source Host
[IP2IPRouting_SrcHost]
CLI: src-host
Destination Username Prefix
[IP2IPRouting_DestUsernamePrefix]
CLI: dst-user-name-prefix
Destination Host
[IP2IPRouting_DestHost]
CLI: dst-host
Request Type
[IP2IPRouting_RequestType]
CLI: request-type
Message Condition
[IP2IPRouting_MessageCondition]
CLI: message-condition
ReRoute IP Group ID
[IP2IPRouting_ReRouteIPGroupID]
CLI: re-route-ip-group-id
Call Trigger
[IP2IPRouting_Trigger]
CLI: trigger
User's Manual
Manipulation'' on page 713.
The default is the asterisk (*) symbol (i.e., any prefix). If this
rule is not required, leave this field empty.
Defines the host part of the incoming SIP dialog's source
URI (usually the From URI).
The default is the asterisk (*) symbol (i.e., any host name). If
this rule is not required, leave this field empty.
Defines the prefix of the incoming SIP dialog's destination
URI (usually the Request URI) user part. You can use
special notations for denoting the prefix. To denote calls
without a user part in the URI, use the $ sign. For available
notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 713.
The default is the asterisk (*) symbol (i.e., any prefix). If this
rule is not required, leave this field empty.
Defines the host part of the incoming SIP dialog's
destination URI (usually the Request-URI).
The default is the asterisk (*) symbol (i.e., any destination
host). If this rule is not required, leave this field empty.
Defines the SIP dialog request type of the incoming SIP
dialog.

[0] All (default)

[1] INVITE

[2] REGISTER

[3] SUBSCRIBE

[4] INVITE and REGISTER

[5] INVITE and SUBSCRIBE

[6] OPTIONS
Assigns a SIP message Condition rule. To configure
Condition rules, see ''Configuring Message Condition Rules''
on page 528.
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This field is
typically used for re-routing requests (e.g., INVITEs) when
interworking is required for SIP 3xx redirect responses or
REFER messages. For more information, see ''Interworking
SIP 3xx Redirect Responses'' on page
''Interworking SIP REFER Messages'' on page 503,
respectively. This parameter functions together with the 'Call
Trigger' field (see below).
The default is -1 (i.e., not configured).
Defines the reason (i.e, trigger) for re-routing the SIP
request:

[0] Any = (Default) This routing rule is used for all
scenarios (re-routes and non-re-routes).

[1] 3xx = Re-routes the request if it was triggered as a
result of a SIP 3xx response.

[2] REFER = Re-routes the INVITE if it was triggered as
a result of a REFER request.

[3] 3xx or REFER = Applies to options [1] and [2].
534
Mediant 1000B Gateway & SBC
Description
500 and
Document #: LTRT-27034