AudioCodes Mediant 1000B User Manual page 849

User's Manual
Parameter
Web: Emergency Calls Regret
Timeout
EMS: Emergency Regret Timeout
CLI: emerg-calls-regrt-t-out
[EmergencyRegretTimeout]
Multilevel Precedence and Preemption (MLPP) Parameters
Web: MLPP Default Namespace
EMS: Default Name Space
CLI: mlpp-dflt-namespace
[MLPPDefaultNamespace]
[ResourcePriorityNetworkDomains] Defines up to 32 user-defined MLPP network domain names
Version 6.8
Example: EmergencyNumbers = '100','911','112'
Defines the time (in minutes) that the device waits before
tearing-down an emergency call (defined by the parameter
EmergencyNumbers). Until this time expires, an emergency call
can only be disconnected by the remote party, typically, by a
Public Safety Answering Point (PSAP).
The valid range is 1 to 30. The default is 10.
Note: This parameter is applicable only to FXS interfaces.
Determines the namespace used for MLPP calls received from
the ISDN side without a Precedence IE and destined for an
Application server. This value is used in the Resource-Priority
header of the outgoing SIP INVITE request.

[1] DSN (default)

[2] DOD

[3] DRSN

[5] UC

[7] CUC
Note: If the ISDN message contains a Precedence IE, the
device automatically interworks the "network identity" digits in
the IE to the network domain subfield in the Resource-Priority
header. For more information, see Multilevel Precedence and
Preemption on page 447.
(namespaces). This value is used in the AS-SIP Resource-
Priority header of the outgoing SIP INVITE request. This
parameter is used in combination with the
MLPPDefaultNamespace parameter, where you need to enter
the table row index as its value.
This parameter is also used for mapping the Resource-Priority
field value of the SIP Resource-Priority header to the ISDN PRI
Precedence Level IE. The mapping is configured by the field,
EnableIp2TelInterworking:

Disabled: The network-domain field in the Resource-Priority
header is set to "0 1 0 0" (i.e., "routine") in the Precedence
Level field.

Enabled: The network-domain field in the Resource-Priority
header is set in the Precedence Level field according to
Table 5.3.2.12-4 (Mapping of RPH r-priority Field to PRI
Precedence Level Value).
The domain name can be a string of up to 10 characters.
The format of this table ini file parameter is as follows:
FORMAT ResourcePriorityNetworkDomains_Index =
ResourcePriorityNetworkDomains_Name,
ResourcePriorityNetworkDomains_EnableIp2TelInterworking;
ResourcePriorityNetworkDomains 1 = dsn, 0;
ResourcePriorityNetworkDomains 2 = dod, 0;
ResourcePriorityNetworkDomains 3 = drsn, 0;
ResourcePriorityNetworkDomains 5 = uc, 1;
ResourcePriorityNetworkDomains 7 = cuc, 0;
849
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC