AudioCodes Mediant 1000B User Manual page 289

User's Manual
The following procedure describes how to configure Message Manipulation rules in the
Web interface. You can also configure Message Manipulation rules using the table ini file
parameter, MessageManipulations or CLI command, configure voip > sbc manipulations
message-manipulations.

To configure SIP message manipulation rules:
1. Open the Message Manipulations page (Configuration tab > VoIP menu > SIP
Definitions > Msg Policy & Manipulation > Message Manipulations).
2. Click Add; the following dialog box appears:
Figure 18-2: Message Manipulations Table - Add Record Dialog Box
3. Configure a Message Manipulation rule according to the parameters described in the
table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
An example of configured message manipulation rules are shown in the figure below:

Index 0: Adds the suffix ".com" to the host part of the To header.

Index 1: Changes the user part of the From header to the user part of the P-Asserted-
ID.

Index 2: Changes the user part of the SIP From header to "200".

Index 3: If the user part of the From header equals "unknown", then it is changed
according to the srcIPGroup call's parameter.

Index 4: Removes the Priority header from an incoming INVITE message.
Version 6.8
Figure 18-3: Message Manipulations Page
289
18. SIP Definitions
Mediant 1000B Gateway & SBC