AudioCodes Mediant 1000B User Manual page 452

3. Configure a supplementary service according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
The figure below displays an example of multiple-line extensions configured in the
Supplementary Services table:
You can register and un-register an endpoint configured in the table. The registration
method is according to the 'Registration Mode' parameter located in the Trunk Group
Settings page (see ''Configuring Trunk Group Settings'' on page 353).

To register or un-register an endpoint:
1. Select the required table row in which the endpoint is configured.
2. From the 'Action' drop-down list, select Register. To unregister the endpoint, select
Un-Register.
Table 26-10: Supplementary Services Table Parameter Description
Parameter
Index
[ISDNSuppServ_Index]
Phone Number
CLI: phone-number
[ISDNSuppServ_PhoneNumber]
Module
CLI: module
[ISDNSuppServ_Module]
Port
CLI: port
[ISDNSuppServ_Port]
User ID
CLI: user-id
[ISDNSuppServ_UserId]
User's Manual
Figure 26-11: Supplementary Services Table Page
Mediant 1000B Gateway & SBC
Description
Defines an index number for the new table record.
Defines a telephone extension number for the
endpoint.
Defines the device's module number to which the
endpoint is connected.
Defines the port number on the module to which the
endpoint is connected.
Defines the User ID for registering the endpoint to a
third-party softswitch for authentication and/or billing.
452 Document #: LTRT-27034