Viewing Ip Connectivity - AudioCodes Mediant 1000B User Manual

User's Manual

43.13 Viewing IP Connectivity

The IP Connectivity page displays on-line, read-only network diagnostic connectivity
information on all destination IP addresses configured in the Outbound IP Routing table
(see ''Configuring Outbound IP Routing Table'' on page 383).
Note:
reset if two minutes elapse without a call to that destination.

To view IP connectivity information:
1. In the Routing General Parameters page, set the 'Enable Alt Routing Tel to IP'
parameter (AltRoutingTel2IPMode) to Enable or Status Only (see ''Configuring
General Routing Parameters'' on page 383).
2. Open the IP Connectivity page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Column Name
IP Address
Host Name
Connectivity
Method
Connectivity
Status
Version 6.8
The information in columns 'Quality Status' and 'Quality Info' (per IP address) is
Figure 43-11: IP Connectivity Page
Table 43-6: IP Connectivity Parameters
The IP address can be one of the following:

IP address defined as the destination IP address in the Outbound IP
Routing table.

IP address resolved from the host name defined as the destination IP
address in the Outbound IP Routing table.
Host name (or IP address) as defined in the Outbound IP Routing table.
The method according to which the destination IP address is queried
periodically (SIP OPTIONS request).
The status of the IP address' connectivity according to the method in the
'Connectivity Method' field.

OK = Remote side responds to periodic connectivity queries.

Lost = Remote side didn't respond for a short period.

Fail = Remote side doesn't respond.
Description
651 Mediant 1000B Gateway & SBC
43. VoIP Status