Call Hold Parameters - AudioCodes Mediant 1000B User Manual

Parameter
CLI: mwi-subs-rtry-time
[SubscribeRetryTime]
Web: Subscription Mode
CLI: subscription-mode
[SubscriptionMode]
EMS: ETSI VMWI Type One
Standard
CLI: etsi-vmwi-type-one-standard
[ETSIVMWITypeOneStandard]
EMS: Bellcore VMWI Type One
Standard
CLI: bellcore-vmwi-type-one-
standard
[BellcoreVMWITypeOneStandard]
51.10.5.5

Call Hold Parameters

The call hold parameters are described in the table below.
Parameter
Web/EMS: Enable Hold
CLI: hold
[EnableHold]
Web/EMS: Hold Format
CLI: hold-format
[HoldFormat]
User's Manual
The default is 120 seconds. The range is 10 to 2,000,000.
Determines the method the device uses to subscribe to an MWI
server.

[0] Per Endpoint = (Default) Each endpoint subscribes
separately - typically used for FXS interfaces.

[1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
Determines the ETSI Visual Message Waiting Indication
(VMWI) Type 1 sub-standard.

[0] = (Default) ETSI VMWI between rings

[1] = ETSI VMWI before ring DT_AS

[2] = ETSI VMWI before ring RP_AS

[3] = ETSI VMWI before ring LR_DT_AS

[4] = ETSI VMWI not ring related DT_AS

[5] = ETSI VMWI not ring related RP_AS

[6] = ETSI VMWI not ring related LR_DT_AS
Note: For this parameter to take effect, a device reset is
required.
Determines the Bellcore VMWI sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note: For this parameter to take effect, a device reset is
required.
Table 51-46: Call Hold Parameters
Global parameter that enables the Call Hold feature (analog interfaces)
and interworking of the Hold/Retrieve supplementary service from ISDN
PRI to SIP. You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_EnableHold). For a detailed description of this
parameter and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 302.
Note: If this functionality is configured for a specific IP Profile, the settings
of this global parameter is ignored for calls associated with the IP Profile.
Defines the format of the SDP in the sent re-INVITE hold request.

[0] 0.0.0.0 = (Default) The SDP "c=" field contains the IP address
"0.0.0.0" and the "a=inactive" attribute.

[1] Send Only = The SDP "c=" field contains the device's IP address
and the "a=sendonly" attribute.

[2] x.y.z.t = The SDP "c=" field contains the device's IP address and
the "a=inactive" attribute.
Notes:
840
Mediant 1000B Gateway & SBC
Description
Description
Document #: LTRT-27034