Configuring Caller Id Permissions - AudioCodes Mediant 1000B User Manual

Parameter
Forward Destination
CLI: destination
[FwdInfo_Destination]
No Reply Time
CLI: no-reply-time
[FwdInfo_NoReplyTime]
27.8

Configuring Caller ID Permissions

The Caller ID Permissions table lets you enable per port, Caller ID generation for FXS
interfaces and Caller ID detection for FXO interfaces.
Note: If Caller ID permissions is not configured for a port in this table, its Caller ID
generation / detection is determined according to the global parameter, 'Enable Call
ID' in the Supplementary Services page (Configuration tab > VoIP menu > GW and
IP to IP > DTMF and Supplementary > Supplementary Services).
The following procedure describes how to configure caller ID permissions in the Web
interface. You can also configure this using the table ini file parameter, EnableCallerID or
the CLI command, configure voip > gw analoggw enable-caller-id.

To configure caller ID permissions per port:
1. Open the Caller ID Permissions page (Configuration tab > VoIP menu > GW and IP
to IP > Analog Gateway > Caller ID Permissions).
2. Click Add; the following dialog box appears:
Figure 27-6: Caller ID Permissions Page - Edit Record
3. Configure a caller ID permission per port according to the parameters described in the
table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 27-5: Caller ID Permissions Table Parameter Descriptions
Parameter
Index
[EnableCallerId_Index]
User's Manual
Defines the telephone number or URI (<number>@<IP address>) to
where the call is forwarded.
Note: If this parameter is configured with only a telephone number and a
Proxy isn't used, this forwarded-to phone number must be specified in
the Outbound IP Routing table (see ''Configuring Outbound IP Routing
Table'' on page 383).
If you have set the 'Type' parameter for this port to No Answer or On
Busy or No Answer, then configure the number of seconds the device
waits before forwarding the call to the specified phone number.
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
466
Mediant 1000B Gateway & SBC
Description
Description
Document #: LTRT-27034