Gateway And Ip-To-Ip Parameters; Fax And Modem Parameters - AudioCodes Mediant 1000B User Manual

Parameter
Web: Gateway RTCP XR Report
Mode
EMS: Report Mode
CLI: rtcp-xr-rep-mode
[RTCPXRReportMode]
Web: SBC RTCP XR Report Mode
CLI: sbc-rtcpxr-report-mode
[SBCRtcpXrReportMode]

51.10 Gateway and IP-to-IP Parameters

51.10.1 Fax and Modem Parameters

The fax and modem parameters are described in the table below.
Parameter
Web: Fax Transport Mode
EMS: Transport Mode
CLI: fax-transport-mode
[FaxTransportMode]
Web: V.21 Modem Transport
Type
EMS: V21 Transport
CLI: V21-modem-transport-type
[V21ModemTransportType]
Web: V.22 Modem Transport
Type
EMS: V22 Transport
CLI: V22-modem-transport-type
[V22ModemTransportType]
User's Manual
Determines whether RTCP XR reports are sent to the Event
State Compositor (ESC) and defines the interval at which they
are sent.

[0] Disable = (Default) RTCP XR reports are not sent.

[1] End Call = RTCP XR reports are sent at the end of each
call.

[2] End Call & Periodic = RTCP XR reports are sent at the
end of each call and periodically according to the
RTCPInterval parameter.
Note: This parameter is applicable only to the Gateway
application.
Enables the sending of RTCP XR reports of QoE metrics at
the end of each call session (i.e., after a SIP BYE). The RTCP
XR is sent in the SIP PUBLISH message.

[0] Disable (default)

[1] End of Call
Note: This parameter is applicable only to the SBC
application.
Table 51-38: Fax and Modem Parameters
Determines the fax transport mode used by the device.

[0] Disable = transparent mode

[1] T.38 Relay (default)

[2] Bypass

[3] Events Only
Note: This parameter is overridden by the parameter IsFaxUsed. If
the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax
Fallback), then FaxTransportMode is always set to 1 (T.38 relay).
Determines the V.21 modem transport type.

[0] Disable = (Default) Transparent.

[2] Enable Bypass

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 302.
Determines the V.22 modem transport type.

[0] Disable = Transparent.

[2] Enable Bypass (default)

[3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
812
Mediant 1000B Gateway & SBC
Description
Description
Document #: LTRT-27034