Configuring Basic Test Call - AudioCodes Mediant 1000B User Manual

49.5

Configuring Basic Test Call

The Basic Test Call feature tests incoming Gateway calls from a remote SIP endpoint to a
simulated test endpoint on the device. The only required configuration is to assign a prefix
number (test call ID) to the simulated endpoint. All incoming calls with this called
(destination) prefix number is identified as a test call and sent to the simulated endpoint.
The figure below displays a basic test call example.

To configure basic call testing:
1. Open the Test Call Settings page (Configuration tab > System menu > Test Call >
Test Call Settings).
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint.
3. Click Submit.
Notes:
•
The Basic Test Call feature tests incoming calls only and is initiated only upon
receipt of incoming calls with the configured prefix.
•
For a full description of this parameter, see ''SIP Test Call Parameters'' on page
740.
•
This call test is done on all SIP interfaces.
•
This call test is applicable only to the Gateway application.
User's Manual
Figure 49-4: Incoming Test Call Example
Figure 49-5: Test Call Settings Page
706
Mediant 1000B Gateway & SBC
Document #: LTRT-27034