Call Pickup; Bri Suspend And Resume; Consultation Feature - AudioCodes Mediant 1000B User Manual

User's Manual
Notes:
•
If a party that is placed on hold (e.g., B in the above example) is called by another
party (e.g., D), then the on-hold party receives a call waiting tone instead of the
held tone.
•
While in a Double Hold state, placing the phone on-hook disconnects both calls
(i.e. call transfer is not performed).
•
You can enable the device to handle incoming re-INVITE messages with
"a=sendonly" in the SDP, in the same way as if "a=inactive" is received in the
SDP. This is configured using the SIPHoldBehavior parameter. When enabled, the
device plays a held tone to the Tel phone and responds with a 200 OK containing
"a=recvonly" in the SDP.
26.2

Call Pickup

The device supports the Call Pick-Up feature, whereby the FXS user can answer someone
else's telephone call by pressing a user-defined sequence of phone keys. When the user
dials the user-defined digits (e.g., #77), the incoming call from the other phone is forwarded
to the FXS user's phone. This feature is configured using the parameter KeyCallPickup.
Note:
same Trunk Group ID.
26.3

BRI Suspend and Resume

The device supports call suspend and resume services initiated by ISDN BRI phones
connected to the device. During an ongoing call, the BRI phone user can suspend the call
by typically pressing the phone's "P" button or a sequence of keys (depending on the
phone), and then on-hooking the handset. To resume the call, the phone user typically
presses the same keys or button again and then off-hooks the phone. During the
suspended state, the device plays a howler tone to the remote party. This service is also
supported when instead of pressing the call park button(s), the phone cable is
disconnected (suspending the call) and then reconnected again (resuming the call).
If the phone user does not resume the call within a user-defined interval (configured using
the HeldTimeout parameter), the device releases the call.
Note:
received from a BRI phone while there is already a suspended call (even if done by
another BRI phone connected to the same trunk), the device rejects this suspend
request.
26.4

Consultation Feature

The device's Consultation feature allows you to place one number on hold and make a
second call to another party.

After holding a call (by pressing hook-flash), the holding party hears a dial tone and
can then initiate a new call, which is called a Consultation call.
Version 6.8
The Call Pick-Up feature is supported only for FXS endpoints pertaining to the
Only one call can be suspended per trunk. If another suspend request is
26. Configuring Supplementary Services
415 Mediant 1000B Gateway & SBC