AudioCodes Mediant 1000B User Manual page 922

Parameter
Web/EMS: Remove CLI when
Restricted
CLI: rmv-cli-when-restr
[RemoveCLIWhenRestricted]
Web/EMS: Remove Calling
Name
CLI: rmv-calling-name
[RemoveCallingName]
Web: Remove Calling Name
EMS: Remove Calling Name
For Trunk Mode
[RemoveCallingNameForTru
nk_x]
Web/EMS: Progress Indicator
to ISDN
CLI: pi-to-isdn
[ProgressIndicator2ISDN_x]
User's Manual
Internet-Draft draft-johnston-sipping-cc-uui-03). For example:
User-to-
User=043030373435313734313635353b313233343b3834;
encoding=hex
where "04" at the beginning of this message is the pd.

[3] = Interworks the SIP User-to-User header containing text
format to ISDN UUIE in hexadecimal format, and vice versa. For
example:
SIP Header in text format:
User-to-User=01800213027b712a;NULL;4582166;
Translated to hexadecimal in the ISDN UUIE:
303138303032313330323762373132613b4e554c4c3b3435
38323136363b
The Protocol Discriminator (pd) used in UUIE is "04" (IUA
characters).
Note: This parameter is applicable for Tel-to-IP and IP-to-Tel calls.
Determines (for IP-to-Tel calls) whether the Calling Number and
Calling Name IEs are removed from the ISDN Setup message if the
presentation is set to Restricted.

[0] No = (Default) IE's are not removed.

[1] Yes = IE's are removed.
Enables the device to remove the Calling Name from SIP-to-ISDN
calls for all trunks.

[0] Disable = (Default) Does not remove Calling Name.

[1] Enable = Removes Calling Name.
Note: Some PSTN switches / PBXs may not be configured to
support the receipt of the "Calling Name" information. These
switches might respond to an ISDN Setup message (including the
Calling Name) with an ISDN
"REQUESTED_FAC_NOT_SUBSCRIBED" failure. This parameter
can be set to Enable (1) to remove the "Calling Name" from SIP-to-
ISDN calls and allow the call to proceed.
Enables the device to remove the Calling Name for SIP-to-ISDN
calls, per trunk.

[-1] Use Global Parameter = (Default) Settings of the global
parameter RemoveCallingName are used.

[0] Disable = Does not remove Calling Name.

[1] Enable = Remove Calling Name.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Determines the Progress Indicator (PI) to ISDN per trunk.

[-1] Not Configured = (Default) The PI in ISDN messages is set
according to the parameter PlayRBTone2Tel.

[0] No PI = PI is not sent to ISDN.

[1] PI = 1; [8] PI = 8: The PI value is sent to PSTN in
Q.931/Proceeding and Alerting messages. Typically, the
PSTN/PBX cuts through the audio channel without playing local
ringback tone, enabling the originating party to hear remote Call
Progress Tones or network announcements.
Note: The x in the ini file parameter name denotes the trunk
922
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034