Sbc Parameters - AudioCodes Mediant 1000B User Manual

User's Manual

51.11 SBC Parameters

The SBC and CRP parameters are described in the table below.
Parameter
CRP-specific Parameters
Web: CRP Application
EMS: Enable CPR Application
CLI: enable-crp
[EnableCRPApplication]
Web: CRP Survivability Mode
CLI: crp-survivability-mode
[CRPSurvivabilityMode]
CLI: crp-gw-fallback
[CRPGatewayFallback]
SBC-specific Parameters
Web/EMS: Enable SBC
CLI: enable-sbc
[EnableSBCApplication]
SBC and CRP Parameters
Web: Unclassified Calls
CLI: unclassified-calls
[AllowUnclassifiedCalls]
Web: SBC No Answer Timeout
CLI: sbc-no-arelt-timeout
Version 6.8
Table 51-70: SBC and CRP Parameters
Enables the CRP application.

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is
required.
Defines the CRP mode.

[0] Standard Mode (default)

[1] Always Emergency Mode

[2] Auto-answer REGISTER
Enables fallback routing from the proxy server to the Gateway
(PSTN).

[0] = Disable (default)

[1] = Enable
Enables the Session Border Control (SBC) application.

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is required.

In addition to enabling this parameter, the number of
maximum SBC/IP-to-IP sessions must be included in the
Software License Key.
Determines whether incoming calls that cannot be classified (i.e.
classification process fails) to a Source IP Group are rejected or
processed.

[0] Reject = (Default) Call is rejected if classification fails.

[1] Allow = If classification fails, the incoming packet is
assigned to a source IP Group (and subsequently
processed) as follows:

The source SRD is determined according to the SIP
Interface to where the SIP-initiating dialog request is
sent. The source IP Group is set to the default IP Group
associated with this SRD.

If the source SRD is ID 0, then source IP Group ID 0 is
chosen. In case of any other SRD, then the first IP
Group associated with this SRD is chosen as the source
IP Group or the call. If no IP Group is associated with
this SRD, the call is rejected.
Defines the timeout (in seconds) for SBC outgoing (outbound IP
routing) SIP INVITE messages. If the called IP party does not
975
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC