AudioCodes Mediant 1000B User Manual page 357

User's Manual
Parameter
Trunk Group Name
CLI: trunk-group-name
[TrunkGroupSettings_TrunkGr
oupName]
MWI Interrogation Type
CLI: mwi-interrogation-type
[TrunkGroupSettings_MWIInterro
gationType]
Version 6.8

The 'Contact User' parameter in the Account table overrides
this parameter (see ''Configuring Registration Accounts'' on
page 279).
Defines a name for the Trunk Group. This name represents the
Trunk Group in the SIP 'tgrp' parameter of the outgoing INVITE
messages (according to RFC 4904). For example:
sip:+16305550100;tgrp=TG-1;trunk-context=+1-
630@isp.example.net;user=phone
The valid value can be a string of up to 20 characters. By default,
no name is configured.
Notes:

If this parameter is not configured, the Trunk Group decimal
number is used in the SIP 'tgrp' parameter.

This feature is enabled by any of the following parameters:

UseSIPtgrp

UseBroadsoftDTG

Currently, this parameter can only be configured using the ini
file.
Defines MWI QSIG-to-IP interworking for interrogating MWI
supplementary services:

[255] Not Configured

[0] None = Disables the feature.

[1] Use Activate Only = MWI Interrogation messages are not
sent and only "passively" responds to MWI Activate requests
from the PBX.

[2] Result Not Used = MWI Interrogation messages are sent,
but the result is not used. Instead, the device waits for MWI
Activate requests from the PBX.

[3] Use Result = MWI Interrogation messages are sent, its
results are used, and the MWI Activate requests are used.
MWI Activate requests are interworked to SIP NOTIFY MWI
messages. The SIP NOTIFY messages are sent to the IP
Group defined by the NotificationIPGroupID parameter.
Note: This parameter appears in the table only if the
VoiceMailInterface parameter is set to 3 (QSIG). Configuring
Voice Mail on page 456.
357
Description
Mediant 1000B Gateway & SBC
22. Trunk Group