AudioCodes Mediant 1000B User Manual page 702

Parameter
Password
CLI: password
[Test_Call_Password]
Test Settings Tab
Call Party
CLI: call-party
[Test_Call_CallParty]
Maximum Channels for Session
CLI: max-channels
[Test_Call_MaxChannels]
Call Duration
CLI: call-duration
[Test_Call_CallDuration]
Calls per Second
CLI: calls-per-second
[Test_Call_CallsPerSecond]
Test Mode
CLI: test-mode
[Test_Call_TestMode]
Test Duration
CLI: test-duration
[Test_Call_TestDuration]
Play
CLI: play
[Test_Call_Play]
User's Manual
Defines the authentication password.
By default, no password is defined.
Defines whether the test endpoint is the initiator or receiving side
of the test call.

[0] Caller (default)

[1] Called
Defines the maximum number of concurrent channels for the test
session. For example, if you have configured an endpoint "101"
and you set this parameter to "3", the device automatically creates
three simulated endpoints - "101", "102" and "103" (i.e.,
consecutive endpoint URIs are assigned).
The default is 1.
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0
means infinite. A value of -1 means that the parameter value is
automatically calculated according to the values of the 'Calls per
Second' and 'Maximum Channels for Session' parameters.
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Defines the number of calls per second.
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value
between the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per
second ('Calls per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test
duration is reached. If it reaches the maximum channels
configured for the test session (in the 'Maximum Channels for
Session'), it waits until the configured call duration of a
currently established tested call expires before making the next
test call. In this way, the test session stays within the
configured maximum channels.
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: This parameter is applicable only if 'Call Party' is set to
Caller.
Enables and defines the playing of a tone to the answered side of
the call.

[0] Disable

[1] DTMF (default) = Plays a user-defined DTMF string,
702
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034