AudioCodes Mediant 1000B User Manual page 721

User's Manual
Parameter
CLI: sys-oid
[SNMPSysOid]
[SNMPTrapEnterpriseOid]
[acUserInputAlarmDescriptio
n]
[acUserInputAlarmSeverity]
[AlarmHistoryTableMaxSize]
CLI: engine-id
[SNMPEngineIDString]
Web: SNMP Trap Destination Parameters
EMS: Network > SNMP Managers Table
CLI: configure system/snmp trap destination
Note: Up to five SNMP trap managers can be defined.
SNMP Manager
[SNMPManagerIsUsed_x]
Web: IP Address
EMS: Address
CLI: ip-address
[SNMPManagerTableIP_x]
Web: Trap Port
EMS: Port
CLI: port
Version 6.8
Defines the base product system OID.
The default is eSNMP_AC_PRODUCT_BASE_OID_D.
Note: For this parameter to take effect, a device reset is required.
Defines the Trap Enterprise OID.
The default is eSNMP_AC_ENTERPRISE_OID.
The inner shift of the trap in the AcTrap subtree is added to the end
of the OID in this parameter.
Note: For this parameter to take effect, a device reset is required.
Defines the description of the input alarm.
Defines the severity of the input alarm.
Defines the maximum number of rows in the Alarm History table.
This parameter can be controlled by the Config Global Entry Limit
MIB (located in the Notification Log MIB).
The valid range is 50 to 1000. The default is 500.
Note: For this parameter to take effect, a device reset is required.
Defines the SNMP engine ID for SNMPv2/SNMPv3 agents. This is
used for authenticating a user attempting to access the SNMP
agent on the device.
The ID can be a string of up to 36 characters. The default is
00:00:00:00:00:00:00:00:00:00:00:00 (12 Hex octets characters).
The provided key must be set with 12 Hex values delimited by a
colon (":") in the format xx:xx:...:xx. For example,
00:11:22:33:44:55:66:77:88:99:aa:bb
Notes:

For this parameter to take effect, a device reset is required.

Before setting this parameter, all SNMPv3 users must be
deleted; otherwise, the parameter setting is ignored.

If the supplied key does not pass validation of the 12 Hex values
input or it is set with the default value, the engine ID is
generated according to RFC 3411.
Determines the validity of the parameters (IP address and port
number) of the corresponding SNMP Manager used to receive
SNMP traps.

[0] (Check box cleared) = Disabled (default)

[1] (Check box selected) = Enabled
Defines the IP address of the remote host used as an SNMP
Manager. The device sends SNMP traps to this IP address.
Enter the IP address in dotted-decimal notation, e.g., 108.10.1.255.
Defines the port number of the remote SNMP Manager. The device
sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default port is
721
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC