AudioCodes Mediant 1000B User Manual page 115

User's Manual
3. Configure an Ethernet Device according to the parameters described in the table
below.
4. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.
Table 12-6: Ethernet Device Table Parameter Descriptions
Parameter
Index
[DeviceTable_Index]
VLAN ID
CLI: vlan-id
[DeviceTable_VlanID]
Underlying Interface
CLI: underlying-if
[DeviceTable_UnderlyingInterface]
Name
CLI: name
[DeviceTable_DeviceName]
Version 6.8
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
Defines a VLAN ID.
The valid value is 1 to 3999. The default value is 1.
Note: Each Ethernet Port Group must be configured with a
unique VLAN ID.
Assigns an Ethernet Port Group to the VLAN (mandatory field).
For configuring Ethernet Port Groups, see Configuring Ethernet
Port Groups on page 111.
Defines a name for the VLAN. This name is used to associate
the VLAN with an IP network interface in the Interface table
('Underlying Device' field - see ''Configuring IP Network
Interfaces'' on page 116) and/or with a static route in the Static
Route table ('Device Name' field - see ''Configuring Static IP
Routing'' on page 123).
By default, the device automatically assigns a name using the
following syntax: "dev <next available table row index>" (e.g.,
"dev 3").
115
Description
Mediant 1000B Gateway & SBC
12. Network