AudioCodes Mediant 1000B User Manual page 938

Parameter
[TimeForReorderTone]
Web: Time Before Reorder
Tone [sec]
EMS: Time For Reorder
Tone
CLI: time-b4-reordr-tn
[TimeBeforeReorderTone]
Web: Cut Through Reorder
Tone Duration [sec]
CLI: cut-thru-reord-dur
[CutThroughTimeForReOr
derTone]
Web/EMS: Enable Comfort
Tone
CLI: comfort-tone
[EnableComfortTone]
[WarningToneDuration]
Web: Play Busy Tone to Tel
CLI: play-bsy-tone-2tel
[PlayBusyTone2ISDN]
User's Manual
starts playing an offhook warning tone.
For digital interfaces: Defines the duration (in seconds) that the CAS
device plays a busy or reorder tone before releasing the line.
The valid range is 0 to 254. The default is 0 seconds for analog
interfaces and 10 seconds for digital interfaces. Note that the Web
interface denotes the default value (for analog and digital interfaces)
as a string value of "255".
Notes:

The selected busy or reorder tone is according to the SIP release
cause code received from IP.

This parameter is also applicable for ISDN when the
PlayBusyTone2ISDN parameter is set to 2.

This parameter can also be configured for a Tel Profile (in the Tel
Profile table).
Defines the delay interval (in seconds) from when the device receives
a SIP BYE message (i.e., remote party terminates call) until the device
starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Defines the duration (in seconds) of the reorder tone played to the
PSTN side after the IP call party releases the call, for the Cut-Through
feature. After the tone stops playing, an incoming call is immediately
answered if the FXS is off-hooked (for analog interfaces) or the PSTN
is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone is
played).
Note: To enable the Cut-Through feature, use the DigitalCutThrough
(for CAS channels) or CutThrough (for FXS channels) parameters.
Determines whether the device plays a comfort tone (Tone Type #18)
to the FXS/FXO endpoint after a SIP INVITE is sent and before a SIP
18x response is received.

[0] Disable (default)

[1] Enable
Note: This parameter is applicable to FXS and FXO interfaces.
Defines the duration (in seconds) for which the offhook warning tone is
played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Notes:

A negative value indicates that the tone is played infinitely.

This parameter is applicable only to analog interfaces.
Enables the device to play a busy or reorder tone to the PSTN after a
Tel-to-IP call is released.

[0] Don't Play = (Default) Immediately sends an ISDN Disconnect
message.

[1] Play when Disconnecting = Sends an ISDN Disconnect
message with PI = 8 and plays a busy or reorder tone to the PSTN
(depending on the release cause).

[2] Play before Disconnect = Delays the sending of an ISDN
Disconnect message for a user-defined time (configured by the
938
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034