AudioCodes Mediant 1000B User Manual page 686

Parameter
Value
CLI: value
[LoggingFilters_Value]
Syslog
CLI: syslog
[LoggingFilters_Syslog]
Capture Type
CLI: capture-type
[LoggingFilters_CaptureType]
User's Manual
Defines the value of the selected filtering type in the 'Filter Type'
parameter.
The value can be the following:

A single value

A range, using a hyphen "-" between the two values, e.g., "1-3"

Multiple, non-contiguous values, using commas "," between
each value, e.g., "1,3,9"

Trunks/FXO/FXS pertaining to a module, using the syntax
module number/port or port, for example:

"1/2", means module 1, port 2

"1/[2-4]", means module 1, ports 2 through 4

Any to indicate all

For IP trace expressions, see ''Filtering IP Network Traces'' on
page 687
Enables Syslog messages for the defined logging filter:

[0] Disable (default)

[1] Enable
Note: This parameter is not applicable when 'Filter Type' is set to
IP Trace.
Enables debug recordings for the defined logging filter and defines
what to record:

[0] None (default)

[1] Signaling = Information related to signaling such as SIP
signaling messages, Syslog, CDR, and the device's internal
processing messages.

[2] Signaling & Media = Signaling and media (RTP/RTCP/T.38).

[3] Signaling & Media & PCM = Signaling, media, and PCM
(voice signals from and to TDM).

[4] PSTN trace = ISDN and CAS traces - applicable only for
Trunk-related filters.
Note: This parameter is not applicable when 'Filter Type' is set to
IP Trace.
686
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034