AudioCodes Mediant 1000B User Manual page 722

Parameter
[SNMPManagerTrapPort_x]
Web: Trap Enable
CLI: send-trap
[SNMPManagerTrapSendingE
nable_x]
Web: Trap User
CLI: trap-user
[SNMPManagerTrapUser_x]
Web: Trap Manager Host Name
CLI: manager-host-name
[SNMPTrapManagerHostNam
e]
SNMP Community String Parameters
Community String
CLI: ro-community-string
[SNMPReadOnlyCommunityS
tring_x]
Community String
CLI: rw-community-string
[SNMPReadWriteCommunity
String_x]
Trap Community String
CLI: community-string
[SNMPTrapCommunityString]
SNMP Trusted Managers Table
Web: SNMP Trusted Managers
CLI: configure system > snmp >
trusted-managers
[SNMPTrustedMgr_x]
SNMP V3 Users Table
Web/EMS: SNMP V3 Users
CLI: configure system > snmp
v3-users
[SNMPUsers]
User's Manual
162.
Enables the sending of traps to the corresponding SNMP manager.

[0] Disable = Sending is disabled.

[1] Enable = (Default) Sending is enabled.
Defines the SNMPv3 USM user or SNMPv2 user to associate with
the trap destination. This determines the trap format, authentication
level, and encryption level. By default, it is associated with the
SNMPv2 user (SNMP trap community string).
The valid value is a string.
Defines an FQDN of the remote host used as an SNMP manager.
The resolved IP address replaces the last entry in the Trap
Manager table (defined by the SNMPManagerTableIP parameter)
and the last trap manager entry of snmpTargetAddrTable in the
snmpTargetMIB. For example: 'mngr.corp.mycompany.com'.
The valid range is a string of up to 99 characters.
Defines up to five read-only SNMP community strings (up to 19
characters each). The default string is 'public'.
Defines up to five read/write SNMP community strings (up to 19
characters each). The default string is 'private'.
Defines the Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Defines up to five IP addresses of remote trusted SNMP managers
from which the SNMP agent accepts and processes SNMP Get
and Set requests.
Notes:

By default, the SNMP agent accepts SNMP Get and Set
requests from any IP address, as long as the correct community
string is used in the request. Security can be enhanced by using
Trusted Managers, which is an IP address from which the
SNMP agent accepts and processes SNMP requests.

If no values are assigned to these parameters any manager can
access the device.

Trusted managers can work with all community strings.
This parameter table defines SNMP v3 users. The format of this
parameter is as follows:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey, SNMPUsers_Group;
[\SNMPUsers]
722
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034