AudioCodes Mediant 1000B User Manual page 300

3. Configure a Tel Profile according to the parameters described in the table below. For a
description of each parameter, refer to the corresponding "global" parameter.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 19-4: Tel Profile Table Parameters and Corresponding Global Parameters
Tel Profile Parameter
Common
Web: Index
[TelProfile_Index]
Web: Profile Name
CLI: profile-name
[TelProfile_ProfileName]
Web: Profile Preference
CLI: tel-preference
[TelProfile_TelPreference]
Web: Fax Signaling Method
CLI: fax-sig-method
[TelProfile_IsFaxUsed]
Web: Enable Digit Delivery
CLI: digit-delivery
[TelProfile_EnableDigitDelivery]
Web: Time For Reorder Tone
CLI: time-for-reorder-tone
[TelProfile_TimeForReorderTone]
Web: Disconnect Call on Detection of Busy
Tone
CLI: disconnect-on-busy-tone
[TelProfile_DisconnectOnBusyTone]
User's Manual
Global Parameter
Defines an index number for the new table record.
Defines an arbitrary name to easily identify the Tel Profile.
The valid value is a string of up to 20 characters.
Defines the priority of the Tel Profile, where 1 is the lowest priority and 20
the highest priority.
Notes:
1. If both the IP Profile and Tel Profile apply to the same call, the coders and
common parameters of the Preferred profile are applied to the call.
2. If the Preference of the Tel Profile and IP Profile are identical, the Tel
Profile parameters are applied.
3. If the coder lists of both the IP Profile and Tel Profile apply to the same
call, only the coders common to both are used. The order of the coders is
determined by the preference.
IsFaxUsed
EnableDigitDelivery
TimeForReorderTone
DisconnectOnBusyTone
300
Mediant 1000B Gateway & SBC
Document #: LTRT-27034