AudioCodes Mediant 1000B User Manual page 950

Parameter
FXO Parameters
Web: FXO Coefficient Type
EMS: Country Coefficients
CLI: fxo-country-coefficients
[CountryCoefficients]
CLI: fxo-dc-termination
[FXODCTermination]
CLI: enable-fxo-current-limit
[EnableFXOCurrentLimit]
[FXONumberOfRings]
Web/EMS: Dialing Mode
CLI: dialing-mode
[IsTwoStageDial]
Web/EMS: Waiting For Dial Tone
User's Manual
required.
Determines the FXO line characteristics (AC and DC)
according to USA or TBR21 standard.

[66] Europe = TBR21

[70] USA = (Default) United States
Note: For this parameter to take effect, a device reset is
required.
Defines the FXO line DC termination (i.e., resistance).

[0] = (Default) DC termination is set to 50 Ohms.

[1] = DC termination set to 800 Ohms. The termination
changes from 50 to 800 Ohms only when moving from
onhook to offhook.
Note: For this parameter to take effect, a device reset is
required.
Enables limiting the FXO loop current to a maximum of 60
mA (according to the TBR21 standard).

[0] = (Default) FXO line current limit is disabled.

[1] = FXO loop current is limited to a maximum of 60 mA.
Note: For this parameter to take effect, a device reset is
required.
Defines the number of rings before the device's FXO
interface answers a call by seizing the line.
The valid range is 0 to 10. The default is 0.
When set to 0, the FXO seizes the line after one ring. When
set to 1, the FXO seizes the line after two rings.
Notes:

This parameter is applicable only if automatic dialing is
not used.

If caller ID is enabled and if the number of rings defined
by the parameter RingsBeforeCallerID is greater than the
number of rings defined by this parameter, the greater
value is used.
Determines the dialing mode for IP-to-Tel (FXO) calls.

[0] One Stage = One-stage dialing. In this mode, the
device seizes one of the available lines (according to the
ChannelSelectMode parameter), and then dials the
destination phone number received in the INVITE
message. To specify whether the dialing must start after
detection of the dial tone or immediately after seizing the
line, use the IsWaitForDialTone parameter.

[1] Two Stages = (Default) Two-stage dialing. In this
mode, the device seizes one of the PSTN/PBX lines
without performing any dialing, connects the remote IP
user to the PSTN/PBX, and all further signaling (dialing
and Call Progress Tones) is performed directly with the
PBX without the device's intervention.
Note: This parameter can be configured for a Tel Profile.
Determines whether or not the device waits for a dial tone
950
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034