AudioCodes Mediant 1000B User Manual page 917

User's Manual
Parameter
CLI: ovrlp-rcving-type
[ISDNRxOverlap]
Web/EMS: Mute DTMF In
Overlap
[MuteDTMFInOverlap]
[ConnectedNumberType]
[ConnectedNumberPlan]
Web/EMS: Enable ISDN
Tunneling Tel to IP
CLI: isdn-tnl-tel2ip
[EnableISDNTunnelingTel2IP
]
Version 6.8
match is found (e.g., for closed numbering schemes) or until a
timer expires (e.g., for open numbering schemes). If a match is
found (or the timer expires), the digit collection process is
terminated even if Sending Complete is not received.

For enabling ISDN overlap dialing for IP-to-Tel calls, use the
ISDNTxOverlap parameter.

The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.

For more information on ISDN overlap dialing, see ''ISDN
Overlap Dialing'' on page 348.
Same as the description for parameter ISDNRxOverlap_x, but for
all trunks.
Enables the muting of in-band DTMF detection until the device
receives the complete destination number from the ISDN (for Tel-to-
IP calls). In other words, the device does not accept DTMF digits
received in the voice stream from the PSTN, but only accepts digits
from ISDN Info messages.

[0] Don't Mute (default).

[1] Mute DTMF in Overlap Dialing = The device ignores in-band
DTMF digits received during ISDN overlap dialing (disables the
DTMF in-band detector).
Note: This parameter is applicable to ISDN Overlap mode only
when dialed numbers are sent using Q.931 Information messages.
Defines the Numbering Type of the ISDN Q.931 Connected
Number IE that the device sends in the Connect message to the
ISDN (for Tel-to-IP calls). This is interworked from the P-Asserted-
Identity header in SIP 200 OK.
The default is [0] (i.e., unknown).
Defines the Numbering Plan of the ISDN Q.931 Connected Number
IE that the device sends in the Connect message to the ISDN (for
Tel-to-IP calls). This is interworked from the P-Asserted-Identity
header in SIP 200 OK.
The default is [0] (i.e., unknown).
Enables ISDN Tunneling.

[0] Disable (default).

[1] Using Header = Enable ISDN Tunneling from ISDN PRI to
SIP using a proprietary SIP header.

[2] Using Body = Enable ISDN Tunneling from ISDN PRI to SIP
using a dedicated message body.
When ISDN Tunneling is enabled, the device sends all ISDN PRI
messages using the correlated SIP messages. The ISDN Setup
message is tunneled using SIP INVITE, all mid-call messages are
tunneled using SIP INFO, and ISDN Disconnect/Release message
is tunneled using SIP BYE messages. The raw data from the ISDN
is inserted into a proprietary SIP header (X-ISDNTunnelingInfo) or a
dedicated message body (application/isdn) in the SIP messages.
Notes:

For this feature to function, you must set the parameter
ISDNDuplicateQ931BuffMode to 128 (i.e., duplicate all
messages).
917
51. Configuration Parameters Reference
Description
Mediant 1000B Gateway & SBC