Quality Of Experience Parameters - AudioCodes Mediant 1000B User Manual

51.5

Quality of Experience Parameters

The Quality of Experience (QoE) parameters are described in the table below.
Parameter
SEM Parameters
Web: Server IP
CLI: configure voip/qoe
configuration/server-ip
[QOEServerIP]
Redundant Server IP
CLI: configure voip > qoe
configuration > set
secondary-server-ip
[QOESecondaryServerIp]
Web: Port
CLI: configure voip/qoe
configuration/port
[QOEPort]
Web: Interface Name
CLI: configure voip/qoe
configuration/interface-name
[QOEInterfaceName]
Quality of Experience Profile Table
Web: Quality of Experience
Profile
CLI: configure voip/qoe qoe-
profile
[QOEProfile]
Quality of Experience Color Rules Table
Web: Quality of Experience
Color Rules
CLI: configure voip/qoe qoe-
profile qoe-color-rules
[QOEColorRules]
User's Manual
Table 51-29: Quality of Experience Parameters
Defines the IP address of AudioCodes primary Session Experience
Manager (SEM) server to where the quality experience reports are
sent.
Note: For this parameter to take effect, a device reset is required.
Defines the IP address of the secondary SEM server to where the
quality experience reports are sent. This is applicable when the
SEM/EMS server is in Geographical Redundancy HA mode.
Note: For this parameter to take effect, a device reset is required.
Defines the port of the SEM server.
The valid value range is 0 to 65534. The default is 5000.
Defines the IP network interface on which the quality experience
reports are sent.
The default is the OAMP interface.
Note: For this parameter to take effect, a device reset is required.
This table parameter defines Quality of Experience Profiles.
The format of the ini file table parameter is as follows:
[QOEProfile]
FORMAT QOEProfile_Index = QOEProfile_Name,
QOEProfile_SensitivityLevel;
[\QOEProfile]
For a detailed description of this table, see ''Configuring Quality of
Experience Profiles'' on page 240.
This table parameter defines Quality of Experience Color Rules.
The format of the ini file table parameter is as follows:
[QOEColorRules]
FORMAT QOEColorRules_Index = QOEColorRules_QoeProfile,
QOEColorRules_ColorRuleIndex, QOEColorRules_monitoredParam,
QOEColorRules_direction, QOEColorRules_profile,
QOEColorRules_GreenYellowThreshold,
QOEColorRules_GreenYellowHysteresis,
QOEColorRules_YellowRedThreshold,
QOEColorRules_YellowRedHysteresis;
[\QOEColorRules]
For a detailed description of this table, see ''Configuring Quality of
Experience Profiles'' on page 240.
756
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034