AudioCodes Mediant 1000B User Manual page 994

Parameter
[EnableIPMediaChannels]
[IPmediaChannels]
Web: Enable Voice Streaming
[EnableVoiceStreaming]
User's Manual
The default is 0.
Notes:

For this parameter to take effect, a device reset is
required.

The SBC application does not require DSP channels.
The SBC application uses DSP channels only if media
transcoding is needed, where two DSP channels are
used per transcoding session.

For IP conferencing, the MPM module must be installed
in Slot #6.

If the MPM is installed in Slot #6, the first DSP channel is
used for a conference and the second DSP, supporting
up to 20 channels, is used for transcoding.

Other DSP channels can be used for PSTN interfaces.
Enables IP media channel support.

[0] = Disable (default)

[1] = Enable
Notes:

When the device is installed with an MPM, this parameter
is enabled by default.

If the device is not installed with an MPM and you want
the device to "borrow" DSP channels from the TRUNKS
modules fro IP media, you must enable this parameter.

For this parameter to take effect, a device reset is
required.
This table ini file parameter defines the number of DSP
channels that are "borrowed" from each of the device's
digital modules for IP media functionality. The format of the
ini file table parameter is as follows:
[ IPMediaChannels ]
FORMAT IPMediaChannels_Index =
IPMediaChannels_ModuleID,
IPMediaChannels_DSPChannelsReserved;
[ \IPMediaChannels ]
For example, the below settings use 15 and 10 DSP
channels from modules 1 and 2, respectively:
IPMediaChannels 1 = 1, 15;
IPMediaChannels 2 = 2, 10;
Notes:

The value of DSPChannelsReserved must be in
multiples of 5 (since the reservation is done per DSP
device and not per DSP channel).

By default, the MPM is set to the maximum value of IPM
channels, therefore, there is no need to define it.

By default, a digital module (i.e., TRUNKS module) is set
to 0 IPM channels.

For DSP utilization options, see DSP Channel Resources
on page 184.
Enables the HTTP Voice Streaming application
(play/record).

[0] Disable (default)
994
Mediant 1000B Gateway & SBC
Description
Document #: LTRT-27034