Sip Test Call Parameters - AudioCodes Mediant 1000B User Manual

Parameter
[GroundKeyDetection]
Web: Port Ground Start
[GroundKeyDetection_x]
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
Web: Ignore BRI LOS Alarm
CLI: ignore-bri-los-alarm
[IgnoreBRILOSAlarm]

51.3.2 SIP Test Call Parameters

The SIP Signaling Test Call parameters are described in the table below.
Parameter
Web: Test Call DTMF
User's Manual
Notes:

For this parameter to take effect, a device reset is required.

If this parameter is set to [2], for this feature to be functional,
both Main and Redundant Power Supply modules must be
housed in the chassis.

If the device is intentionally installed with only one Power Supply
module, then make sure that this parameter is set to [1];
otherwise, an alarm will be raised.
Defines loop- or ground-start signaling for all the device's FXS and
FXO ports.

[0] = (Default) Loop-start signaling

[1] = Ground-start signaling
Notes:

For this parameter to take effect, a device reset is required.

For configuring the signaling method per port and for a detailed
description of this feature, see Configuring Ground- or Loop-
Start Signaling per Analog Port on page 183.
This table parameter defines loop- or ground-start signaling per
analog (FXS or FXO) port.
For the ini file parameter, the x denotes the port number, where 0
represents Port I. For example,
GroundKeyDetection_0 = 1
GroundKeyDetection_1 = 0
GroundKeyDetection_2 = 0

[0] Disable = (Default) Port uses loop-start signaling.

[1] Enable = Port uses ground-start signaling.
For more information, see Configuring Ground- or Loop-Start
Signaling per Analog Port on page 183.
Notes:

For this parameter to take effect, a device reset is required.

For configuring the same signaling method for all ports, use the
ini file parameter GroundKeyDetection.
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)

[1] Enable
Enables the device to ignore LOS alarms received from the BRI
user-side trunk and attempts to make a call (relevant for IP-to-Tel
calls).

[0] Disable

[1] Enable (default)
Table 51-20: SIP Test Call Parameters
Defines the DTMF tone that is played for answered test calls (incoming
740
Mediant 1000B Gateway & SBC
Description
Description
Document #: LTRT-27034