Collecting Debug Recording Messages - AudioCodes Mediant 1000B User Manual

User's Manual
45.7

Collecting Debug Recording Messages

To collect debug recording packets, use the open source program Wireshark. AudioCodes
proprietary plug-in files for Wireshark are required.
Notes:
•
The default debug recording port is 925. You can change the port in Wireshark
(Edit menu > Preferences > Protocols > AC DR).
•
The plug-in files are per major software release of Wireshark. For more
information, contact your AudioCodes sales representative.
•
The plug-in files are applicable only to Wireshark 32-bit for Windows.

To install Wireshark and the plug-ins for debug recording:
1. Install Wireshark on your computer. The Wireshark program can be downloaded from
http://www.wireshark.org.
2. Download the proprietary plug-in files from www.audiocodes.com/downloads.
3. Copy the plug-in files to the directory in which you installed Wireshark, as follows:
...\dtds\cdr.dtd
...\plugins\<Wireshark ver.>\*.dll
...\tpncp\tpncp.dat
4. Start Wireshark.
5. In the Filter field, type "acdr" (see the figure below) to view the debug recording
messages. Note that the source IP address of the messages is always the OAMP IP
address of the device.
Version 6.8
Copy this file
689
45. Syslog and Debug Recordings
To this folder on your PC
Wireshark\dtds\
Wireshark\plugins\<Wireshark ver.>
Wireshark\tpncp
Mediant 1000B Gateway & SBC