AudioCodes Mediant 1000B User Manual page 914

BRI Parameters
BRI Layer 2 Mode
CLI: isdn-layer2-mode
[BriLayer2Mode]
CLI: tei-config-p2p (config-voice >
interface bri <module/port>)
[BriTEIConfigP2P_x]
CLI: tei-config-p2mp (config-voice >
interface bri <module/port>)
[BriTEIConfigP2MP_x]
CLI: tei-assign-trigger (config-voice
> interface bri <module/port>)
User's Manual
Defines Point-to-Point (P2P) or Point-to-Multipoint (P2MP)
mode for BRI ports.

[0] Point to Point (default)

[1] Point to Multipoint = Must be configured for Network
side.
Defines the BRI terminal endpoint identifier (TEI) when in
point-to-point (P2P) mode.
The valid value is 0 to 63, 127. The default is 0.

Network Side:

0-63: Static TEI is accepted.

127: Any possible TEI is accepted. Dynamic TEI
allocation is supported.

User Side:

0-63: Static TEI is used.

127: Dynamic TEI allocation is supported (TEI
request procedure initiated).
Note: The value 127 replaces the previous configuration
requirement to set the ISDNIBehavior parameter to NS
EXPLICIT INTERFACE ID (1).
Defines the BRI TEI when in point-to-multipoint (P2MP)
mode.
The valid value is 0 to 63, 127. The default is 127.

Network Side: Not applicable - In network side in P2MP
configuration, any TEI must be accepted.

User Side:

0-63: Static TEI is used.

127: Dynamic TEI allocation is supported (TEI
request procedure initiated).
Defines when to start the TEI assignment procedure.
The valid values are (bit-field parameter):
914
Mediant 1000B Gateway & SBC
Parameter
Document #: LTRT-27034
Description
is
set:
0x9
1 =
RO
SE.

[3] =
Use
options
[0] and
[2]
above.
Note: For
this
parameter
to take
effect, a
device
reset is
required.