Configuring Voip Lan Interface For Oamp; Web Interface - AudioCodes Mediant 1000B User Manual

User's Manual
4

Configuring VoIP LAN Interface for OAMP

You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page

Embedded command line interface (CLI) - see ''CLI'' on page
4.1

Web Interface

The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.

To configure the VoIP-LAN IP Address for OAMP, using the Web interface:
1. Connect one of the Ethernet ports located on the CRMX module directly to the
network interface of your computer, using a straight-through Ethernet cable.
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the
default IP address of the device; the Web interface's Web Login screen appears:
b. In the 'Username' and 'Password' fields, enter the case-sensitive, default login
username ("Admin") and password ("Admin").
c. Click Login.
4. Open the Physical Ports Settings page (Configuration tab > VoIP menu > Network >
Physical Ports Table) and then configure the device's physical Ethernet port-pair
(group) that you want to later assign to the OAMP interface. For more information, see
Configuring Physical Ethernet Ports on page 109.
Version 6.8
Figure 4-1: Web Login Screen
31
4. Configuring VoIP LAN Interface for OAMP
33
Mediant 1000B Gateway & SBC
31