User's Manual
29
SBC Configuration
This chapter describes the configuration of the SBC application.
29.1
Configuring General Settings
The General Settings page allows you to configure general SBC parameters. For a
description of these parameters, see ''SBC Parameters'' on page 975.
To configure general parameters:
1.
Open the General Settings page (Configuration tab > VoIP menu > SBC > General
Settings).
2.
Configure the parameters as required.
3.
Click Submit.
4.
To save the changes to flash memory, see ''Saving Configuration'' on page 568.
29.1.1 Interworking Dialog Information in SIP NOTIFY Messages
You can enable the device to interwork dialog information (XML body) received in SIP
NOTIFY messages from a remote (WAN) application server. The NOTIFY message is sent
by application servers to notify a SIP client, subscribed to a service and located behind the
device (LAN), of the status of another SIP client in the LAN. For example, user B can
subscribe to an application server for call pick-up service, whereby if user A's phone rings,
the application server notifies user B. User B can then press a pre-configured key
sequence to answer the call.
Version 6.8
Figure 29-1: General Settings Page
515
29. SBC Configuration
Mediant 1000B Gateway & SBC